![]() ![]() Carefully lift the amplifier plate – you can safely hold and pull by the 8 high level connectors. WARNING: DO NOT pull by the wires, however tempting that may seem!Ģ. Best approach is to use small bent nose pliers as shown holding the end of the spade connector. Be careful, leads inside are rather short. Start by lifting the bottom side as shown and drop the top left corner in, turning the plate to the left side. Speaker is connected via two spade connectors, the photo below shows the easiest position to turn the amplifier plate after you removed the screws. Disconnect the two speaker cables from the board inside. Unscrew the 8 screws marked on the photo below.Ģ. Reassembly is the reverse of disassembly. It’s always a good idea to take a few photos in the process. Here you can find more detailed information on removing the amplifier plate for the different KEF subwoofer models as follows:
0 Comments
Leave a Reply. |